Pin may be permanently installed in pipe with 2 part epoxy and stainless set screws or welded in place.
Fitting can be used where there is insufficient mounting area for our standard base.
Bright dip anodized to a marine grade standard.
Mounting base is 2†in diameter and has two countersunk mounting holes for 1/4-20 oval or flat head mounting bolts. Matching back up plate is 3 1/2†in diameter and is pre-drilled for the mounting bolts.
Backing plates may be trimmed to fit into a smaller area if required.
Pin secured to the mounting pad with a 3/8†stainless allen bolt.
Nylon washers between female mounting pad and male pin eliminate metal to metal which can cause oxide staining and noise.